Your HVAC system stops working overtime. That alone drops your energy consumption—commercial systems account for over 30% of building energy use, and dirty ducts make that number climb even higher.
Your employees stop complaining about stuffy air, headaches, and allergy symptoms that seem to disappear on weekends. Indoor air quality improves because you’re not recirculating dust, debris, and whatever else has been sitting in those ducts for years.
Your equipment lasts longer. When your system isn’t straining to push air through clogged ductwork, it doesn’t break down as often. You’re looking at fewer emergency repair calls and a system that actually reaches its expected lifespan instead of dying early.
The work gets done outside business hours if that’s what you need. Your operations don’t stop, your customers don’t notice, and you’re not explaining to employees why it sounds like a jet engine in the ceiling at 2 PM on a Tuesday.
We’ve been handling HVAC duct cleaning for commercial facilities across Guilford, Randolph, Alamance, and Forsyth Counties for over 30 years. We’re not new to Vandalia, NC or the surrounding area—we’ve cleaned systems in hospitals, industrial plants, schools, and office buildings throughout the region.
We employ more NADCA-certified Air System Cleaning Specialists than any company in the southeast. Rick Watson holds ASCS and CVI certifications, and Noah Watson is ASCS certified. That’s not just letters after names—it means they’ve put in the time to learn how to clean commercial HVAC systems the right way, following ACR standards that facilities worldwide rely on.
We’re local, we’re certified, and we’ve seen what happens when duct cleaning gets done poorly. That’s why we follow NADCA’s source removal methods—physically removing contaminants instead of just stirring them around and calling it clean.
We start with an inspection of your entire HVAC system. That includes the ductwork, registers, grilles, coils, drain pans, and air handling units. If we’re only cleaning part of the system, the rest just recontaminates what we cleaned—so we look at everything.
Next comes the actual cleaning using source removal methods. We use specialized tools to physically dislodge debris, then extract it with high-powered vacuum equipment. This isn’t a spray-and-pray situation—we’re removing what’s built up in there, not just moving it around.
We clean every component that air touches. Coils, fans, drain pans, supply and return ducts—all of it. Skipping components means you’re back where you started within months.
If we find leaks during the inspection, we’ll let you know. Duct leaks can waste up to 30% of your energy, so sealing them makes sense from a cost standpoint. We can handle that too, but we’ll explain what we found and let you decide.
The whole process typically happens outside business hours. Most commercial projects get scheduled during shutdowns, weekends, or after-hours to avoid disrupting your operations. We coordinate timing that works for your facility.
Ready to get started?
You’re getting a full HVAC system cleaning—not just the easy-to-reach parts. That means supply and return air ducts, registers, grilles, diffusers, heat exchangers, cooling coils, condensate drain pans, fan motors, and the air handling unit housing.
In Vandalia, NC and the surrounding Piedmont Triad area, we’re dealing with humidity, pollen, and seasonal allergens that love to settle in ductwork. Commercial buildings here accumulate dust and organic material faster than you’d think—especially if your system runs constantly or you’re in manufacturing, food service, or healthcare.
We follow NADCA standards because they work. The ACR standard is specified for commercial projects worldwide, and it’s built on source removal—the only method proven to actually eliminate accumulated contaminants instead of just redistributing them.
After the cleaning, you’ll have documentation of what was done. If you’re in an industry with regulatory requirements around indoor air quality, that paperwork matters. We provide it as part of the service.
NADCA recommends commercial duct cleaning every 3 to 5 years, but your timeline depends on your facility type, occupancy, and what your system deals with daily. We’ll give you an honest assessment based on what we see, not a sales pitch for unnecessary service.
Most commercial duct cleaning projects run between $400 and $1,000, but that’s a broad range because every facility is different. Your actual cost depends on your building’s square footage, how many ducts you have, how they’re configured, and how accessible everything is.
A small office building with a straightforward system costs less than a multi-story facility with complex ductwork running through tight spaces. If your system hasn’t been cleaned in a decade and there’s significant buildup, that takes longer than maintenance cleaning on a system that was serviced two years ago.
We’ll give you a clear quote after looking at your system. No surprises, no “well actually” conversations later. The quote covers the full cleaning—all components, not just the visible parts—and any scheduling accommodations you need for after-hours work.
Yes, but let’s be specific about why. When your ductwork is clogged with dust and debris, your HVAC system has to work harder to move air through the building. That means it’s running longer cycles and consuming more energy to maintain the same temperature.
Clean ducts reduce that resistance. Your system moves air more efficiently, runs shorter cycles, and uses less energy overall. You’re also preventing the 30% energy loss that comes from duct leaks—which we identify during cleaning and can seal if needed.
The energy savings vary based on how dirty your system was and how efficient your equipment is to begin with. But when commercial HVAC systems account for 30% or more of your building’s energy consumption, even a 10-15% improvement in efficiency shows up on your utility bills. Most facility managers notice the difference within the first billing cycle after cleaning.
It depends entirely on your facility size and system complexity. A small commercial building with a single HVAC unit might take 4-6 hours. A larger facility with multiple units, extensive ductwork, and hard-to-reach components can take a full day or longer.
We typically schedule commercial projects outside business hours—evenings, weekends, or during planned shutdowns—so the timeline matters less than making sure we’re not disrupting your operations. If you need the work done over multiple nights to avoid downtime, we can structure it that way.
The actual cleaning can’t be rushed if you want it done right. Source removal cleaning means physically accessing every component, dislodging contaminants, and extracting them. Cutting corners to save an hour just means you’re paying for incomplete work. We’ll give you an accurate time estimate upfront based on what we see during the initial inspection.
Commercial systems are larger, more complex, and deal with higher contaminant loads. A residential system might have 10-15 vents; a commercial building can have 50 or more, spread across multiple floors with ductwork running through areas that aren’t easy to access.
Commercial facilities also have different air quality demands. If you’re running a medical office, school, or food service operation, indoor air quality isn’t just about comfort—it’s about compliance and liability. The stakes are higher, and the cleaning process has to be more thorough.
The equipment is different too. Commercial duct cleaning requires industrial-grade vacuum systems and specialized tools that can handle the scale and complexity of commercial HVAC systems. That’s why NADCA certification matters—it’s proof that the technicians actually know how to work on commercial systems, not just residential setups. We focus on commercial work because that’s where our certifications and experience are concentrated.
Start with what you can see. If there’s visible dust or debris coming out of supply vents, or if the vent covers themselves are caked with buildup, that’s a clear sign. Check your air filters—if they’re getting dirty unusually fast, your ducts are likely full of contaminants that keep recirculating.
Pay attention to what your building occupants are saying. If employees are complaining about stuffy air, allergy symptoms, headaches, or respiratory issues that improve when they leave the building, poor indoor air quality is often the culprit. Dirty ductwork harbors dust, mold, bacteria, and allergens that get distributed every time your system runs.
Look at your energy bills. If your HVAC costs have been creeping up without a clear explanation—no rate increases, no changes in occupancy or hours—your system might be working harder due to restricted airflow from dirty ducts. NADCA recommends cleaning every 3-5 years as a baseline, but if you’re seeing these signs, don’t wait for the calendar to tell you it’s time.
Yes, and we do it regularly. Commercial duct cleaning is loud and intrusive if it’s happening during business hours—that’s just the reality of the equipment and process involved. So we schedule most projects outside your operating hours.
That usually means evenings, weekends, or during planned facility shutdowns when the building is empty or minimally staffed. We coordinate with your facility manager to find windows that work for your schedule. If the job needs to happen over multiple sessions to avoid disruption, we structure it that way.
We’ve cleaned systems in hospitals, schools, and office buildings throughout Guilford and Randolph Counties where downtime wasn’t an option. It takes more planning and flexibility on our end, but it’s standard practice for commercial work. You shouldn’t have to choose between clean ducts and running your business—we make sure you get both.
Local Resources
Useful Links
Other Services we provide in Vandalia
